The shower solution on the right is comfortable – the GROHE Aquadimmer is an operating lever that allows to choose between the overhead or hand shower and controls the flow rate at the same time.
The shower solution on the left is versatile – a separate stop valve allows the side showers and the overhead shower to be used at the same time.
Installation information:
In the shower solution shown, both showers can be used independently of each other. The temperature can be set individually for each side.
When dimensioning the drain, make sure that the maximum amount of water produced can run off safely. Operating this shower with an instantaneous water heater is not recommended. The hot water storage tank should be sufficiently large. When all showers are used at the same time, up to 360 litres of hot/cold water are needed in 10 minutes.
The connections to the showers should be executed in DN 20.
Water quantities:
Minimum requirements to ensure good functioning of this shower solution:
Recommended pressure: 1.5 bar ahead of the thermostat fitting
